Thursday’s Tip: New 3D Embossing Folder Plate

By | 27 June 2019

Stampin’ Up! have introduced a new 3D Embossing Folder Plate to work with their new-style 3D embossing folders (which are thinner than our old-style Dynamic folders).

3D Embossing Folder Plate

How to Use the New 3D Embossing Folder Plate

The new plate makes up the difference in measurement between our old-style Dynamic Folders and our new-style 3D Folders in 21 mm gap machines (similar to the machine we used to offer). The 3D Embossing Folder Plate replaces the Standard Cutting Pads in your 3D embossing folder sandwich for continued high-quality emboss results.

To create your emboss sandwich:

Use a die-cutting & embossing machine platform as a base; no matter which machine you’re using, use the standard platform which comes with your machine.
Use the 3D Embossing Folder with your paper in the middle.
Then use the 3D Embossing Folder Plate on top.
Given the differences in machines and platforms, you may still have to add a shim to get your desired embossing results. (You can also spritz your paper before embossing to maximise your embossed impressions.)

Without the new 3D Embossing Folder Plate, you will need to use several shims with the Standard Cutting Pad in your 3D embossing folder sandwich, depending on the die-cutting & embossing machine you use. Most machines will need between three to five sheets of cardstock to shim. Please be careful in how you shim; start out with fewer sheets first, then add sheets to get your desired results. Stampin’ Up! will not be responsible to replace products broken due to using a sandwich which is too thick for a machine.

You can check out the range of Stampin’ Up! embossing folders here. This includes the 3D ones as well as the standard ones.

If you would like to purchase the 3D Embossing Folder Plate, you can purchase it from my online store here.

Leave a Reply

Your email address will not be published. Required fields are marked *